![]() This feature can be useful for remotely turning on a computer and saving energy by avoiding keeping it constantly powered on. In this guide, we have seen how to configure Wake-on-LAN on a Debian GNU/Linux system, SysLinuxOS, using systemd. The computer should start up after receiving the magic packet. $ sudo apt-get install wakeonlan etherwake To test Wake-on-LAN, send a magic packet over the network using a tool like wakeonlan or etherwake: $ sudo tee /etc/systemd/network/10-enp3s0.link is the MAC address of the computer’s network card.ĭetermine the MAC address of the target device you want to wake up: Step 2 – Configure systemd to enable Wake-on-LAN at boot The letter “ d” means that WOL on the card is disabled. Remote operations can be executed manually on demand and automatically on schedule. ![]() This power management software allows you to manage network PCs from a central location and run remote Shutdown, Wake-on-LAN, Reboot, Sleep and other operations on multiple network PCs remotely. Supported pause frame use: Symmetric Receive-onlyĪdvertised link modes: 10baseT/Half 10baseT/FullĪdvertised pause frame use: Symmetric Receive-only Remote Shutdown - Free Shutdown and Wake-on-LAN Tool for Networks. Supported link modes: 10baseT/Half 10baseT/Full If the command returns a line with “ Wake-on: d“, it means that the network card supports WoL. Where is the name of the network interface (e.g., eth0 or enp3s0). You can do this by running the following command: In this guide, we will see how to configure Wake-on-LAN on a Debian-based system, SysLinuxOS, using systemd.īefore proceeding, it’s important to check that the computer’s network device supports Wake-on-LAN. ![]() To use this feature, you need to enable WoL support in the BIOS/UEFI and configure the operating system to detect and respond to magic packets. Wake-on-LAN (WoL) is a feature that allows you to turn on a computer remotely by sending a magic packet over the network. How to configure Wake-on-LAN using systemd ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |